Luckily there are companies out there that buy these powders in the large quantities and re-sell them in much smaller quantities. Additional charges will apply. Thanks. Only a few weeks after I received my first powder coating gun and no prior experience, I took this shifter assembly from this condition.. to this condition. This perfectly seals off the caliper piston bore while powder coating and sandblasting. Powercoating comes in high temps that withstand temps of upto 1000f but require complete blasting of material and are very sensitive in nature requiring very specific procedures while applying for a durable finish. Good day sir. Unfortunately ECPC cannot offer any warranties or gaurentees, as each user is responsible for how they handle and care for their coated parts. I have a question about my powdered parts..I had my shovel head powdered 1.5 yrs ago..its my show bike..I now have damaged powder coating.. Its bad...I had a powder coating company tell me my parts are wet paint..can I please get more information as how to tell exactly.. And can I post pictures to show everyone so you guys can give me honest opinions on this matter before I go in asking for a refund?? or more. hy im new to powder coating and few metal parts have been great but when i tryed my alloy calipers and hangers theres lots of pin holes appeared so after researching i should de-gas so i tryed by putting item in oven at 230 degrees C for around 15 mins then letting cool then powder coat but still same finish what am i doing wrong cheer ste. I wanted to venture in the field of powder coating as we do get it done in huge volumes from other vendors. Spray paint doesn't even come close the durability of powder coat. Sean,Just found these articles. Where powder coating is discussed there is no mention of paint removal. If you can find an old Eastwood Pro gun, it is virtually identical to the older EZ50s and works very well. You will then mask off either the face of the wheel, or the lip, depending on which color you are coating next. Depending on how well you want the final finish to look, you can either cleanly mask off an area close to the hole and live with a raised edge or you can treat it more like an autobody repair and mask off a wide are around the hole, spray the area and cut and buff the newly sprayed powder to try to blend it in. You will make mistakes and have parts not come out right. thanks for reply ill try primer , your link does not work what make primer do i need im in the uk by the way cheers ste. I'm not familiar with G30 brackets or PEM hardware. It's a process getting people to understand what we do, but the process gets easier with sites like this... so thank you! These averages should be only a very loose guideline. I really like my parts to be looking nice when I'm finished with them. Thank you so much! I have used iron phosphate pre-treaments in the past, but after I used it all up, I decided not to order any more. Then set up the propane heater and get the area up to the cure temp and then start your timer. The method I would recommend if you plan on doing frames frequently, is to use a chemical stripper to remove the paint, then sandblast in order to add some profile to the frame, then powder coat. Great site!!! Even if the piece is brand new, it should be cleaned. If you are just looking for a gun to shoot the occasional display panel or a couple of brackets, any of the cheap cup guns should work well enough for that purpose.